Kenwood DNX 9210 BT Guía de inicio rápido descargar pdf (Pagina 27)

EN 27

DNX9210BT

Connecting wires to terminals (2)

Connect to the vehicle’s

parking brake detection

switch harness.

PRK SW

REVERSE

For best safety, be sure to connect the

parking sensor.

Connect to vehicle’s reverse lamp harness

when using the optional rear view camera.

Light Green (Parking sensor wire)

Accessory 1

Purple/White (Reverse sensor wire)

To use the steering wheel remote control feature,

you need an exclusive remote adapter (not

supplied) matched to your car.

Light Blue/Yellow

(Steering remote control wire)

Brown (Mute control wire)

Blue/White (Power control/

Antenna control wire)

Connect to the terminal that is grounded when

either the telephone rings or during conversation.

To use the Mute feature, you need to hook up this

wire to your telephone by using a commercial

telephone accessory.

Depending on what antenna you are using, connect

either to the control terminal of the motor antenna,

or to the power terminal for the booster amplifier

of the film-type antenna. (Max. 300mA, 12V)

If no connections are made,

do not let the cable come out from the tab.

To steering remote

REMOTE CONT

MUTE

ANT.

CONT

P. CONT

STEERING WHEEL

REMOTE INPUT

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 115 116

Sin comentarios

Kenwood DNX 9210 BT Guía de inicio rápido Pagina 27